F4200N Manual - Fisnar.fr

F4200N Operating Manual
Section 5: Point Type & Function Reference
Part # 562187N
Rev. C Jun 2011
6
7
8
Instruction
Type 3 to specify three rows, and then press
ENTER.
In the above example, the X Offset between
parts is 30 mm.
Type 30 to specify an X Offset of 30 mm, and
then press ENTER.
In the above example, the Y Offset between
parts is 25 mm.
Type 25 to specify 25 mm, and then press
ENTER.
The display will prompt you to select 1. S Path or
2. N. Path.
Display Shows
Step & Repeat
Address, 8
---------------------
X Offset:
Y Offset:
Unit: mm
Step & Repeat
Address, 8
---------------------
X Offset: 30
Y Offset:
Unit: mm
Step & Repeat
Address, 8
---------------------
1. S Path
2. N Path
Select:
9
Selecting S Path will cause the first row 1 to 4 to
be dispensed, then the second row 4 to 1, and
then the third row 1 to 4.
Selecting N PATH will cause the first row 1 to 4
to be dispensed, then the second row 1 to 4, and
then the third row 1 to 4.
Addr: 9
Empty
Prog:20
Press 1 to select S PATH, and then press
ENTER.
The program is now complete.
10
Press ENTER, and then select End Program to
mark address 9 as the new End Program
instruction.
Addr: 10
Empty
Prog:20
Press the 7 key then press ENTER.
Press RUN to run the program.
- Page 38 - © 2011 Fisnar Inc.