F4200N Manual - Fisnar.fr
F4200N Manual - Fisnar.fr
F4200N Manual - Fisnar.fr
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>F4200N</strong> Operating <strong>Manual</strong><br />
Section 1: Introduction<br />
Part # 562187N<br />
Rev. C Jun 2011<br />
1. Safety Precautions<br />
1.1 Make sure the robot is connected to a properly grounded power source before<br />
operating.<br />
1.2 Keep away <strong>fr</strong>om any moving parts while the robot is running.<br />
1.3 Loading and unloading of parts and material must only be done when the robot is at<br />
a complete stop.<br />
1.4 Changing of fixtures or tooling must be done with the power source disconnected.<br />
1.5 The <strong>F4200N</strong> robot should only be operated in an environment between 0 and 40<br />
degrees Celsius with humidity of 20 to 95 percent and no visible condensation.<br />
1.6 Do not store or setup the robot in an area where it is directly exposed to sunlight.<br />
1.7 Do not operate the robot where electrical noise is present.<br />
1.8 Only use a neutral chemical for cleaning the robot. Do not use alcohol, benzene or<br />
thinner as it may damage the paint on the robot.<br />
1.9 Due to the electronic nature of this equipment and the potential for a spark or<br />
generation of heat, note that this equipment most NOT be used with any explosive<br />
material or in an explosive type environment.<br />
- Page 5 - © 2011 <strong>Fisnar</strong> Inc.