F4200N Manual - Fisnar.fr
F4200N Manual - Fisnar.fr
F4200N Manual - Fisnar.fr
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>F4200N</strong> Operating <strong>Manual</strong><br />
Section 5: Point Type & Function Reference<br />
Part # 562187N<br />
Rev. C Jun 2011<br />
1.12.1 Brush Area: Rectangle<br />
Brush Area Rectangle causes the tip to „paint‟ the defined area by passing back and forth<br />
along the X-axis, while moving the Y-axis a determined Brush Width distance after each<br />
pass along the X-axis.<br />
After registering the Brush Area Rectangle command, teach a Line Start point at the top<br />
left corner of the area to be brushed and a Line End point at the bottom right corner of that<br />
area (the tip will not dispense a straight line between these two points):<br />
Line Start<br />
Paint<br />
Area<br />
Line End<br />
If, for example, a brush width of 5 mm was used, the tip will take the following path when<br />
the program is run:<br />
5 mm<br />
5 mm<br />
5 mm<br />
5 mm<br />
- Page 42 - © 2011 <strong>Fisnar</strong> Inc.