F4200N Manual - Fisnar.fr

F4200N Operating Manual
Section 5: Point Type & Function Reference
Part # 562187N
Rev. C Jun 2011
The instruction at memory address 8 should be changed from End Program to Step &
Repeat X. To register a Step & Repeat X instruction at memory address 8, do the
following:
1
2
3
Instruction
Press the +1 or –1 keys until memory address 8
is shown in the display
Press the Enter key, and then press the X key
to change to page 2. Select Step & Repeat by
pressing the key 3.
Type 1 to select X direction, and then press
ENTER.
The display will prompt you for the Start Addr:
Display Shows
ADDR: 8 PROG: 20
End Program
Step & Repeat
Address, 8
---------------------
1.X 2.Y,
Start Address,
Columns (X):
Rows (Y):
Step & Repeat
Address, 8
---------------------
1.X 2.Y, 1
Start Address,
Columns (X):
Rows (Y):
[F1] Address [F2]Label
4
5
The start address is the memory address of the
first instruction, which is part of this Step &
Repeat group.
In our example, we want to repeat all instructions
starting with memory address number 4.
Type 4 to specify memory address 4, and then
press ENTER.
Type 4 to specify four columns, and then press
ENTER.
Step & Repeat
Address, 8
---------------------
1.X 2.Y, 1
Start Address, 4
Columns (X):
Rows (Y):
Step & Repeat
Address, 8
---------------------
1.X 2.Y, 1
Start Address, 4
Columns (X): 4
Rows (Y):
- Page 37 - © 2011 Fisnar Inc.