F4200N Manual - Fisnar.fr
F4200N Manual - Fisnar.fr
F4200N Manual - Fisnar.fr
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>F4200N</strong> Operating <strong>Manual</strong><br />
Section 5: Point Type & Function Reference<br />
Part # 562187N<br />
Rev. C Jun 2011<br />
1. F1 (Point Menu)<br />
Below is a list of functions which are found under the ENTER key. These functions are<br />
„point-type‟ functions, meaning that the values applied will occupy one memory address.<br />
Please see SECTION 6:Sample Programs for additional programming examples.<br />
1.1 Dispense Dot<br />
Registers the current XYZ location as a dispense point for dot dispensing.<br />
The dispense time and wait time must be set in a previous memory address by registering<br />
a Point Dispense Setup instruction.<br />
The upward motion of the tip after dispensing can be controlled by registering a Dispense<br />
End Setup instruction and / or a Z Clearance instruction in a previous memory address.<br />
Dispense End Setup and Z Clearance instructions are registered using the SETUP key.<br />
See also SECTION 5:5.3 Point Dispense Setup, SECTION 5:5.4 Dispense End Setup<br />
and SECTION 5:5.5 Z Clearance.<br />
1.2 Line Start<br />
Registers the current XYZ location as a Line Start point for line dispensing.<br />
The line speed must be set in a previous memory address by registering a Line Speed<br />
instruction using the SETUP key.<br />
Dispense delay times used at Line Start and Line End points can be controlled by<br />
registering a Line Dispense Setup instruction in a previous memory address. The Line<br />
Dispense Setup instruction is registered by pressing the SETUP key.<br />
See also SECTION 5:5.1 Line Speed and SECTION 5:5.2 Line Dispense Setup.<br />
- Page 31 - © 2011 <strong>Fisnar</strong> Inc.