LabChip GX/GXII User Manual

Software Reference 129Graph View (Continued)To show or change the labels on the peaks in the graph, show thedata points on the graph, show peak baselines, or change the graphcolors, see “Graph View Properties” on page 134.To select a peak on the graph, move the cursor near the peak. Ablue arrow above the peak shows that the peak is selected, and thecursor changes to an arrow that points straight up. The Gel Viewand Peak Table View also select the corresponding entry.You can adjust the peak baselines from the graph view, if desired.Select Show Peak Baselines in the Graph View Properties todisplay the baseline for each peak. To change the baseline, clickthe triangle at either end of the peak baseline and drag to thedesired location. To reset the baseline back to the original position,right-click near the baseline end point and choose Reset toDefaults.While a run is in progress, the Active Data Tab displays the raw(unanalyzed) data as it is being read from the chip. As data isacquired, the selected well increments to the well that is currentlybeing run, and the data displays in real time.Graph View Shortcut MenusRight-Click Menu (not near a peak)Right-click away from a peak in the graph to display a shortcutmenu containing the following commands:Unzoom - zooms out to the previous zoom level.Unzoom All - zooms out completely and returns to the standardview.Set Scale - Opens the Set Graph Scales window to specify the Xand Y ranges to show on the graph.Scale to Sample Peaks - Scales the view to the minimum andmaximum X values of the current sample peaks. Marker and/orsystem peaks are ignored.Scale to All Peaks - Scales the view to the minimum and maximumX values of the all peaks, including marker peaks and systempeaks.Copy - Copies the selected graph to the clipboard in a .bmp format.Analysis Settings - Opens the Assay Analysis Window to changethe analysis settings.P/N 127170 Rev. 00 LabChip GX User Manual Caliper Life Sciences, Inc.