LabChip GX/GXII User Manual

Software Reference 192Plate Information WindowUse the Plate Information window to view, add, or change platenames and measurements. To open the Plate Information window,select Tools Plate Editor on the LabChip GX Main Window.Figure 81. Plate Information WindowThe Plate Information window contains the following tabs:• Predefined Plates - Displays Caliper-defined plates. Theseplates are read-only and cannot be edited or deleted.• Custom Plates - Displays all user-created plates. Plates can beadded, deleted, and modified.The Plate Information window contains the following options andbuttons:Plate InformationtableDelete SelectedPlateAdd PlateModify SelectedPlateVerify PlateClose buttonDisplays the plate information for each plate defined for use inthe system. (See “Add Plate Window” on page 152 for adescription of each column.)Deletes the selected plate from the system. (Only availablewhen the Custom Plates tab is selected.)Opens the Add Plate Window to enter the information for anew plate. (Only available when the Custom Plates tab isselected.)Opens the Add Plate Window to edit the information for theselected plate. (Only available when the Custom Plates tab isselected.)Opens the Verify Plate window to perform a puncture testusing the selected plate information. Follow the instructions inthe Verify Plate window to test the settings for the selectedplate.Closes the Plate Information window.P/N 127170 Rev. 00 LabChip GX User Manual Caliper Life Sciences, Inc.