CSI-F-10 User manual - Hydac

GSM Radio Module CSI-F-10 Page 1049.8.3 T - FlipflopThe T-FlipFlop function is the representation of a surge relay. Theoutput switches over every time the Boolean input value changesfrom "0" to "1". (Toggle function, hence the name T-Flipflop).A side effect of the T-FlipFlop is that it halves the frequency of acounting signal.The output is set to 0 after initialization at the time of program start.Inputs: x: (Boolean)Outputs: y: (Boolean)Parameters: -9.8.4 Mono FlopThe output switches on when the Boolean input value switches from"0" to "1". The function is comparable to the automatic switching of alight in a stairwell.The output is set to 0 after initialization at the time of program start.When the Reset input is set to "1", then the output is definitely set to"0".• Not retriggerableWhen the flank switches from "0" to "1", the output for thespecified time is switched to "1". After the time elapses, theoutput is set back to "0". It doesn't matter whether or not thisflank occurs again during this time.• RetriggerableWhen the flank switches from "0" to "1", the output for thespecified time is switched to "1". After the time elapses, theoutput is set back to "0". If the flank switches from "0" to "1"once again during this time, then the output will be switchedagain to "1" for the time specified.• ProlongableWhen the flank switches from "0" to "1", the output for thespecified time is switched to "1". If no change of flanks occurredduring this time, then the output remains switched to "1" until theflank switches from "1" to "0".Inputs: x 0 : S (Boolean)x 1 : R (Boolean)Outputs: y: (Boolean)Parameters: p1: Modep2: Time in secondsStatus 2011/08/17 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752