CSI-F-10 User manual - Hydac

More documents

Recommendations

Info

GSM Radio Module CSI-F-10 Page 54• You can set up a list of telephone numbers (address book) under Telephonelist.• Click on “OK“ to apply the entries or “Cancel“ to discard these changes. Ineither case you will then return to the Connection window.• Click on Open to open the selected interface. The open interface is indicated bya green dot at the top right.• Click on "Change" to open the window for the pass-through mode.Status 2011/08/17 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
GSM Radio Module CSI-F-10 Page 55• Select the HSI address of the CMU 1000 connected to the CSI-F-10 in theselection window (Address a in our example).• Afterwards, click on Switch on in order to switch on the pass-through mode forthe selected channel.• The following message appears:• Confirm this with OK.• Afterwards click on Connect to connect the PC to the CMU 1000 that isconnected with the CSI-F-10Status 2011/08/17 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
Page 1 and 2:
GSM Radio ModuleCSI-F-10User Manual
Page 3 and 4: GSM Radio Module CSI-F-10 Page 3Tab
Page 5 and 6: GSM Radio Module CSI-F-10 Page 59.2
Page 7 and 8: GSM Radio Module CSI-F-10 Page 711.
Page 9 and 10: GSM Radio Module CSI-F-10 Page 91 G
Page 11 and 12: GSM Radio Module CSI-F-10 Page 112
Page 21 and 22: GSM Radio Module CSI-F-10 Page 21Co
Page 23 and 24: GSM Radio Module CSI-F-10 Page 23PI
Page 25 and 26: +U BGNDGSM Radio Module CSI-F-10 Pa
Page 53: GSM Radio Module CSI-F-10 Page 536.
Page 105 and 106:
GSM Radio Module CSI-F-10 Page 1059
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
GSM Radio Module CSI-F-10 Page 119S
show all

CSI-F-10 User manual - Hydac

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?