CSI-F-10 User manual - Hydac

GSM Radio Module CSI-F-10 Page 14The two basic operating modes available for using the GSM radio module CSI-F-10 aredescribed below:3.1 Stand alone operationThe CSI-F-10 transmits the measured values and additional information of theconnected sensors directly and without processing them (passive mode) or monitorsand processes the input signals with a "CM program" stored in the unit (active mode).The application software for the active mode, das "CM Program", can be readilygenerated by the user using the "CM Editor" on a PC. The "CM Editor" is a componentpart of the HYDAC PC software "CMWIN", version 3.0 or higher.In the above-mentioned "CM program" you define in detail which data will be monitoredand how, and when and which type of message should occur.For example, once a parameterized limit has been exceeded, an alarm SMS can besent or a switch output can be set. All texts and telephone numbers for the relevantSMS must be stored in the CM program by the user.Note!All of the programming procedures and software functions subsequently described inthis documentation refer to the "CM Editor" in accordance with IEC 61131.The operator is responsible for the safe and application-appropriate functioning of theCM Programs that he or she generates.3.2 Operation as GSM modem on a CMU 1000When using the unit as a GSM modem, the CSI-F-10 must be connected via HSI signal(HYDAC sensor interface) to the CMU 1000. The CMU 1000 is in this case the "busmaster" and controls the radio module.In this operating mode, one or more sensors are monitored by the CMU 1000. Theirinput signals are evaluated according to the CM program stored in the CMU 1000 andprocessed.The resulting data and / or messages are transmitted from the CMU 1000 via HSIinterface to the GSM radio module. The radio module transfers this data and / ormessages controlled by the CMU 1000 directly by SMS.The SMS text and the receiving telephone number are stored in the CM program in theCMU 1000 for this purpose.Status 2011/08/17 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752