CSI-F-10 User manual - Hydac

More documents

Recommendations

Info

GSM Radio Module CSI-F-10 Page 11210.2.9 No Inscription for Numerical InputThe numerical input value must have an inscription.► Enter an inscription in the function properties.10.2.10 Duplicate Inscription for Numerical InputThe inscription of a numerical input value must be unambiguous within a CM programand is only permitted to occur once for that reason.► Check the inscription and correct it.10.2.11 Duplicate Error SourceA setting is made for an error source to indicate which error will be the output of theerror source. No error source may be present more than once in a CM program.► Check the setting under "Error messages" and correct it.10.3 Error Messages for Operations/Conditions10.3.1 Upper and Lower Measured Value Limits too Close to one anotherFor functions with upper and lower value limits, the two values must be at least 10steps apart.► Check the values that were entered and correct them.10.3.2 Measured Value Limits Outside the Range of -30000 to 30000For functions with upper and lower value limits, the entered values must be between -30,000 and +30,000.► Check the values that were entered and correct them.10.3.3 Lower Measured Value Limit Greater than Upper MeasurementValue LimitFor functions with upper and lower measured value limits, the lower measured valuemust be less than the upper measured value.► Check the values that were entered and correct them.10.4 Error Messages with Result Values/Actions10.4.1 Invalid Output LED SelectedThe selected LED does not exist in this device and must be set correctly.► Check the LED setting and correct it.10.4.2 Duplicate Use of Output LEDThe selected LED is already being used in the current CM program and may notappear twice.► Check the LED selection and correct it.Status 2011/08/17 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
GSM Radio Module CSI-F-10 Page 11310.4.3 Invalid Digital OutputThe quantity of digital outputs is device-dependent. This error is set when an outputterminal is selected that a device doesn't have.► Check the selection and correct it.10.4.4 Duplicate Digital OuputThe output terminal of the digital output must not occur more than once in a CMprogram.► Check the output terminal which has been set and correct it.10.4.5 Too Many Boolean Output FieldsThe quantity of Boolean output fields in one CM program is device-dependent.► Reduce the Boolean output fields to the device-specific maximum.10.4.6 Duplicate Boolean Output FieldThe inscription of a Boolean output field must not occur more than once in a CMprogram.► Check the inscription and correct it.10.4.7 The Bit Number Must Be a Figure between 0 and 14The property "Bit number" must not lie outside the range of 0 ... 14 for the Booleanoutput field function.► Check the value that was entered and correct it.10.4.8 Too Many Numerical Output FieldsThe quantity of numerical output fields in one CM program is device-dependent.► Reduce the numerical output fields to the device-specific maximum.10.4.9 Duplicate Numerical Output FieldThe inscription of a numerical output field must not be present more than once in aCM program.► Check the inscription and correct it.10.4.10 Message and telephone number too longThe length of the message + telephone number together is limited to 230 characters.► Check the relevant entries and correct them.Status 2011/08/17 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
Page 1 and 2:
GSM Radio ModuleCSI-F-10User Manual
Page 3 and 4:
GSM Radio Module CSI-F-10 Page 3Tab
Page 5 and 6:
GSM Radio Module CSI-F-10 Page 59.2
Page 7 and 8:
GSM Radio Module CSI-F-10 Page 711.
Page 9 and 10:
GSM Radio Module CSI-F-10 Page 91 G
Page 11 and 12:
GSM Radio Module CSI-F-10 Page 112
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
GSM Radio Module CSI-F-10 Page 21Co
Page 23 and 24:
GSM Radio Module CSI-F-10 Page 23PI
Page 25 and 26:
+U BGNDGSM Radio Module CSI-F-10 Pa
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62: GSM Radio Module CSI-F-10 Page 61
Page 63 and 64: GSM Radio Module CSI-F-10 Page 637.
Page 111: GSM Radio Module CSI-F-10 Page 1111
Page 119 and 120: GSM Radio Module CSI-F-10 Page 119S
show all

CSI-F-10 User manual - Hydac

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?