CSI-F-10 User manual - Hydac

GSM Radio Module CSI-F-10 Page 73• You can transfer the currently opened CM program to the CSI-F-10 with"Transfer into device“.Note!Only error-free programs can be transferred into the CSI-F-10.• The following message appears after the program has been successfullytransferred:• Here you can select whether you also wish to transfer the source code of theprogram into the CSI-F-10.Note!If the source code is also transferred into the CSI-F-10, then it is possible for itto be read again by every other connected PC and modified! If the sourcecode is not also transferred into the CSI-F-10, then the program cannot beuploaded by another PC.• The following message will appear if the CM program contains errors whenattempting transfer:• Eliminate the error(s) found in the CM program (see Chap. 8.2.2 "Function list“window and Chap. 10. "Error messages“) and transfer the program again.Note!If you transfer a program and a power failure occurs during the transfer, thenthe program will not be saved in the CSI-F-10 after power is restored. For thatreason, first save your program on the PC on which it was originally generatedor modified before making the transfer.Status 2011/08/17 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752