CSI-F-10 User manual - Hydac

GSM Radio Module CSI-F-10 Page 536.6.2 Connection Setup• Start the HYDAC PC software CMWIN• In the Units Menu, select the "CM Manager" option.• If the Connection window does not open automatically, select"Connection" in the menu bar of the CM Manager.• Select the option "Modem Connection" option in the window that opens.• Click on "Change" to open the window for the interface settings.• Make the corresponding preselection for the port settings in the window thatopens under Interface selection.• Select the relevant port address and Baud rate (9600 for GSM) under Interfacesettings.• Click "Refresh" to update the interfaces marked under Interface selection interms of availability.• Click on “OK“ to apply the modified settings or “Cancel“ to discard thesechanges. In either case you will then return to the Connection window.• Click on "Change" to open the window for entering the telephone numbers.Telephone number of theSIM card in the CSI-F-10PIN number of the SIMcardin the PC modem• Enter the telephone number of the SIM card which is in the GSM radio moduleCSI-F-10.• In the Pin field enter the PIN code (if one has been assigned) for the SIM cardof the modem connected to the PC. If no PIN code has been assigned, thenleave the field empty.Status 2011/08/17 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752