CSI-F-10 User manual - Hydac

More documents

Recommendations

Info

GSM Radio Module CSI-F-10 Page 326.3.2.3 Connecting to the sensor by connection 2 (HSI address "b")• Click on "Disconnect" under Connection in the Device box to break the existingPC connection with the CSI-F-10.• The following window opens:• Then click on "No", so that the bus master is not reactivated.• (!) 1 see Page 30• Select Change in the Bus address line.Status 2011/08/17 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
GSM Radio Module CSI-F-10 Page 33• The following window opens:• Select the appropriate device address in the selection window(Address b in our example).• Confirm this with OK.• Click on Connect to establish a link with the sensor.• Successful establishment of the connection will be signaled as shown below:• Click on Ok to connect the connection setup or on Disconnect to cancel theconnection setup.Status 2011/08/17 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
Page 1 and 2: GSM Radio ModuleCSI-F-10User Manual
Page 3 and 4: GSM Radio Module CSI-F-10 Page 3Tab
Page 5 and 6: GSM Radio Module CSI-F-10 Page 59.2
Page 7 and 8: GSM Radio Module CSI-F-10 Page 711.
Page 9 and 10: GSM Radio Module CSI-F-10 Page 91 G
Page 11 and 12: GSM Radio Module CSI-F-10 Page 112
Page 21 and 22: GSM Radio Module CSI-F-10 Page 21Co
Page 23 and 24: GSM Radio Module CSI-F-10 Page 23PI
Page 25 and 26: +U BGNDGSM Radio Module CSI-F-10 Pa
Page 31: GSM Radio Module CSI-F-10 Page 31
Page 83 and 84:
GSM Radio Module CSI-F-10 Page 839.
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
GSM Radio Module CSI-F-10 Page 1019
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
GSM Radio Module CSI-F-10 Page 119S
show all

CSI-F-10 User manual - Hydac

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?