CSI-F-10 User manual - Hydac

GSM Radio Module CSI-F-10 Page 37• In the Interface field, select the option "Open" in order to open the selectedinterface (COM port).The opened interface will be indicated by a green dot on the right-hand edge ofthe window.• In the Sensor field, specify whether you would like to connect to the CSI-F-10GSM radio module direct, or to one of the sensors connected to it.• Click on "Change" to open the window for the pass-through mode.• Select Switch on, to transfer the HMG 510 into the pass-through mode.Afterwards the following message appears:• Confirm this with OK.• "Com Mode" appears in the display of the HMG 510.Note!In the pass-through mode a device connected to the PC (in this case: HMG 510)transfers the data direct to on of the connected sensors or to another device (in thiscae: CSI-F-10) and vice-versa. The PC is then no longer linked to the device directlyconnected to it.In the following example, a HYDACLab ® with the address "a" is connected toconnection 1 and a CS 1000 is connected to a CS 1000 with the address "b“ (see alsoChapter 6.3.2).• Afterwards, proceed according to the three options described below.Status 2011/08/17 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752