CSI-F-10 User manual - Hydac

GSM Radio Module CSI-F-10 Page 929.4.5 Median ValueThe Median value function outputs the arithmetical median value ofthe input values over an adjustable time range.The time range is set in seconds using the Time parameter.The median value is formed according to the "Repeating Average"procedure. This means that, when the time setting is "2 seconds",for example, the input values are compiled for 2 seconds, thenaveraged and output at the output. The next median value intervalbegins after that. The output value pauses on the last median value.Inputs: x: Input value (Numerical)Outputs: y: Median value (Numerical)Parameters: p 1 : Time (Numerical)9.4.6 Note ValueThe Note value function is used to hold on to certain values (tofreeze them). It has one numerical and one Boolean input.If the Boolean input value is "1", then the numerical input value isoutput at the output. If the Boolean input value is "0", then the lastoutput value continues to be output.If the value is only to be applied for one flank of the Boolean input,then you can put the function Pulse generation upstream from it (seeChap. 9.8.6).Inputs: x 1 : Input value (Numerical)x 2 : Switch value through (Boolean)Outputs: y: (Numerical)Parameters: -9.4.7 Note MinimumThe Note minimum function outputs the smallest value that the inputvalue has yet reached.If the input value is greater than the output value, then the outputvalue remains unchanged. If the input value is less, then the outputvalue will be reset.The minimum can be reset with the Boolean input x 2 . The inputvalue will be applied directly at the output for as long as this input is"1".Inputs: x 1 : Input value (Numerical)x 2 : Reset (Boolean)Outputs: y: (Numerical)Parameters: -Status 2011/08/17 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752