CSI-F-10 User manual - Hydac

GSM Radio Module CSI-F-10 Page 829.2 Data Sources9.2.1 Numerical ConstantThe Numerical Constant function supplies a numerical value whichis defined in the Editor and which does not change during therunningtime.That means that the Value parameter entered in the Editor is outputduring the running time at the output.Inputs: -Outputs: y: (Numerical)Parameters: p 1 : Value (Numerical)9.2.2 Measured valueThe Measured Value function provides the current measured valueof a connected sensor.The Sensor connection parameter is used to define the sensor; thechannel of the sensor with Subchannel. If a connected sensor hasno subchannel, then no selection is possible at this point.If a sensor constellation has been saved, then only the activeconnections are displayed in the input lists for the Sensorconnection, each of them with the relevant sensor name. Thesubchannels available for this sensor are then displayed atSubchannel, each of them with name and unit.If no sensor constellation is saved, then Ports "A" to "P" are offeredfor selection at Sensor connection and Channels "1" to "32"at Subchannel.Inputs: -Outputs: y: (Numerical)Parameters: p 1 : Sensor connection (input list)p 2 : Subchannel (input list)9.2.3 Digital InputThe Digital input function supplies the status of a digital input.The Input terminal parameter is used to define which digital inputport is used.Inputs: -Outputs: y: (Boolean)Parameters: p 1 : Input terminal (input list)Status 2011/08/17 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752