User Manual High Performance AC Drive

Important User InformationSolid state equipment has operational characteristics differing from those ofelectromechanical equipment. Safety Guidelines for the Application,Installation and Maintenance of Solid State Controls (Publication SGI-1.1available from your local Rockwell Automation sales office or online at http://www.rockwellautomation.com/literature) describes some important differencesbetween solid state equipment and hard-wired electromechanical devices.Because of this difference, and also because of the wide variety of uses for solidstate equipment, all persons responsible for applying this equipment mustsatisfy themselves that each intended application of this equipment isacceptable.In no event will Rockwell Automation, Inc. be responsible or liable for indirector consequential damages resulting from the use or application of thisequipment.The examples and diagrams in this manual are included solely for illustrativepurposes. Because of the many variables and requirements associated with anyparticular installation, Rockwell Automation, Inc. cannot assume responsibilityor liability for actual use based on the examples and diagrams.No patent liability is assumed by Rockwell Automation, Inc. with respect to useof information, circuits, equipment, or software described in this manual.Reproduction of the contents of this manual, in whole or in part, withoutwritten permission of Rockwell Automation, Inc. is prohibited.Throughout this manual, when necessary we use notes to make you aware ofsafety considerations.!WARNING: Identifies information about practices orcircumstances that can cause an explosion in a hazardousenvironment, which may lead to personal injury or death, propertydamage, or economic loss.Important: Identifies information that is critical for successful application andunderstanding of the product.!ATTENTION: Identifies information about practices orcircumstances that can lead to personal injury or death, propertydamage, or economic loss. Attentions help you:• identify a hazard• avoid the hazard• recognize the consequencesShock Hazard labels may be located on or inside the equipment(e.g., drive or motor) to alert people that dangerous voltage may bepresent.Burn Hazard labels may be located on or inside the equipment(e.g., drive or motor) to alert people that surfaces may be atdangerous temperatures.PowerFlex is a registered trademark of Rockwell Automation, Inc.DriveExplorer, DriveExecutive, and SCANport are trademarks of Rockwell Automation, Inc.PLC is a registered trademark of Rockwell Automation, Inc.