User Manual High Performance AC Drive

Chapter 2Start-UpThis chapter describes how to start-up the PowerFlex 700S Drive. Refer toAppendix D for a brief description of the HIM (Human Interface Module).For Information on …See Page...Prepare for Drive Start-Up 2-1Assisted Start-Up 2-5!ATTENTION: Power must be applied to the drive to performthe following start-up procedure. Some of the voltages present areat incoming line potential. To avoid electric shock hazard ordamage to equipment, only qualified service personnel shouldperform the following procedure. Thoroughly read andunderstand the procedure before beginning. If an event does notoccur while performing this procedure, Do Not Proceed.Remove Power including user supplied control voltages. Usersupplied voltages may exist even when main AC power is notapplied to then drive. Correct the malfunction before continuing.Prepare for Drive Start-UpBefore Applying Power to the DriveImportant: If you have a DriveLogix application, you must first connectthe battery before starting this section.❏1. Confirm that motor wires are connected to the correct terminals and aresecure. Confirm Frame 5 transformer connections (refer to page 1-11).T1UT2VT3WPE❏❏2. If an encoder is used, confirm the encoder wires are connected to thecorrect terminals and are secure.3. Confirm that all control inputs are connected to the correct terminals andare secure.