User Manual High Performance AC Drive

Index-4Parameters, GroupsCommunication 3-4Dynamic Control 3-3Inputs & Outputs 3-4Monitor 3-3Motor Control 3-3Position Control 3-4Process Control 3-3Speed Control 3-3Speed/Posit Fdbk 3-4Torque Control 3-3User Functions 3-4Utility 3-4PE 1-5Permanent Magnet Motor Specifications I-1Permanent Magnet MotorsCompatible Motors I-1Motor Name Plate and RatingSpecifications I-1Phase SelectionInput 1-10Phase Selection Jumper 1-14Position ControlPosition Config 3-9Power 1-9Power Conditioning, Input 1-5Power SupplyAuxiliary 1-23, A-18Power Terminal Block 1-9, 1-14Location 1-14Power Wiring 1-7Powering Up the Drive 2-1Precautions P-4PrechargeCommon Bus 1-10DC 1-10Preferences, Setting D-4Process ControlRegulator 3-8Programmable Controller ConfigurationsA-4RRCDResidual Current Detector 1-4Recommended 1-21, F-3Recommended CablesCables F-3Recommended Documentation P-1Recommended Grounding Scheme 1-5Reflected Wave 1-8Removal 1-10Access Panel 1-10Removing the CassetteCassetteRemoval 1-2Removing the Side Covers 1-2Reset to Defaults D-4Residual Current Detector 1-4ResistorBrake 1-16Resolver E-1, G-1Resolver FeedbackSpecifications G-1Wiring G-3Resolver Feedback Option Card E-1, G-1Resolver Interface Board A-18RotaryStegmann H-2Rotary EncodersStegmann H-2Run InhibitCommon CausesRun Inhibit 2-4, 4-3SSaving Data D-4SchemeRecommended Grounding 1-5SelectionJumper 1-14Setting Preferences D-4Shielded CablesPower 1-8SHLD Terminal 1-6Side CoversRemoving 1-2Signal Wire 1-21Sinking Input/Output 1-26Sourcing Input/Output 1-26Spare Connectors A-18, E-1, G-1Specifications 1-14, A-1