User Manual High Performance AC Drive

17219Installation/Wiring 1-11Table 1.D Fan VA RatingFrame Fan Voltage(120V or 240V)5 100 VA6 138 VASelecting/Verifying Fan Voltage (Frames 5 & 6 Only)!ATTENTION: To avoid a shock hazard, ensure that allpower to the drive has been removed before performingthe following.Frames 5 & 6 utilize a transformer to match the input line voltage to theinternal fan voltage. If your line voltage is different than the voltage classspecified on the drive nameplate, it may be necessary to change thetransformer taps. The taps are shown in the insert of frame 5 below.Figure 1.2 Frames 5 & 6 Jumper and Transformer Locations (Frame 5 shown)Phase SelectionJumper3-PH 1-PHLINETYPESPARE 1OptionalCommunicationsModuleSPARE 2POWER TERMINAL RATINGSWIRE RANGE: 14-1/0 AWG (2.5-35 MM 2 )TORQUE: 32 IN-LB (3.6 N-M)STRIP LENGTH: 0.67 IN (17 MM)USE 75 C CU WIRE ONLYGROUND TERMINAL RATINGS (PE)300 VDC EXT PWR SPLY TERM (PS+, PS-)WIRE RANGE: 22-10 AWG (0.5-4 MM 2 )TORQUE: 5.3 IN-LB (0.6 N-M)STRIP LENGTH: 0.35 IN (9 MM)Fan VoltageWIRE RANGE: 6-1/0 AWG (16-35 MM 2 )TORQUE: 44 IN-LB (5 N-M)STRIP LENGTH: 0.83 IN (21 MM)OUTPUTINPUT AC690 Volt Tap600 Volt Tap480 Volt Tap400 Volt TapFrame 6 Transformer Tap AccessThe transformer is located behind the Power Terminal Block in the areashown in Figure 1.2. Gain access by releasing the terminal block from therail. To release terminal block and change tap: