User Manual High Performance AC Drive

Start-Up 2-5Table E Common Start-Up FaultsFault Description ActionEncoder Loss One of the following has occurred on an encoder: Reconnect encoder or replace encoder.• missing encoder (broken wire)• quadrature error• phase lossMotor Overload A motor overload is pending. Enter correct motor nameplate full load amps. Par 2 [Motor NPFLA] or reduce excess load.Motor Poles Fault The poles of the motor do not match its rating. Enter correct motor nameplate information. Par 4 [Motor NP RPM]If any digital input is configured to Stop - CF (CF=Clear Faults) verify thesignal is present or the drive will not start. Refer to Chapter 4 for a list ofpotential digital input conflicts.If a fault code appears, refer to Chapter 4.The STS LED should be flashing green at this point.❏8. Proceed to Start-Up Routine.Assisted Start-UpThis routine prompts you for information needed to start-up a drive for mostapplications, such as line and motor data, commonly adjusted parametersand I/O.Important: When using the Start-Up Assistant, always exit the Assistant beforecycling power on the drive. Failure to exit may leave unwanted settingsactive in the drive configuration.If, after exiting the Start-Up Assistant, external sources inhibit drive start,check Par 671 [Start Mask].The assisted start-up routine asks simple yes or no questions and promptsyou to input required information. Access Assisted Start-Up by selecting“Start-Up” from the Main Menu.Step Key(s) Example LCD Displays1. To exit the User Display screen, Press Esc.EscFStopped0.0 0.00.0AutoRPMDC Bus VOutput C