AutoCAD 2018 and Inventor 2018 Tutorial By Tutorial Books (www.engbookspdf.com)

Part 1: AutoCAD Basics
Define second chamfer distance :
Press ENTER to accept 8 as the second chamfer
distance.
Select the drawing by clicking on it, and
then press Enter.
Select first line or
[Undo/Polyline/Distance/Angle/Trim/mEthod/
Multiple]: Select the vertical line on the rightside.
Select second line or shift-select to apply
corner or [Distance/Angle/Method]: Select the
horizontal line connected to the vertical line.
Select the first point of the mirror line as
shown below.
Make sure that the Ortho Mode on the
status bar is active.
Move the pointer toward right and click.
The Mirror tool
The Mirror tool creates a mirror image of
objects. You can create symmetrical drawings
using this tool. Activate this tool and select the
objects to mirror, and then define the ‘mirror line’
about which the objects will be mirrored. You can
define the mirror line by either creating a line or
selecting an existing line.
Select the No option from the command line
to retain the source objects.
Click Home > Modify > Mirror on the
ribbon or enter MI in the command line.
86