AutoCAD 2018 and Inventor 2018 Tutorial By Tutorial Books (www.engbookspdf.com)

Part 1: AutoCAD Basics
Click the Add Pick Points button from the
Boundaries group and click in Region 1,
Region 2 and Region 3.
Example:
Create four layers with the following
settings.
Layer Lineweight Linetype
Construction 0.00 mm Continuous
Object 0.30 mm Continuous
Centerline 0.00 mm CENTER2
Hatch lines 0.00 mm Continuous
Create the following drawing in different
layers. Do not apply dimensions.
Press ENTER to create hatch lines.
Save the drawing as Crank.dwg and close.
Setting the Properties of Hatch lines
You can set the properties of the hatch lines such as
angle, scale, transparency in the Properties panel of
the Hatch Creation ribbon.
Type H and press ENTER; the Hatch
Creation tab appears in the ribbon.
Select the Pattern option from the Hatch
Type drop-down in the Properties panel.
177