AutoCAD 2018 and Inventor 2018 Tutorial By Tutorial Books (www.engbookspdf.com)

Part 2: Autodesk Inventor Basics
8. On the ribbon, click Sketch > Constrain >
Dimension.
9. Select the ellipse, move the cursor downward,
and click
10. Type 2 and press Enter.
11. Select the ellipse, move the cursor toward left,
and click.
12. Type 1.35 and press Enter.
13. Select the origin point of the sketch and the
center point of the ellipse.
14. Move the cursor toward left and click to place
the dimension between the selected point.
15. Type 2.55 and press Enter.
16. Right click and select Line from the Marking
Menu.
17. Right click and select Construction from the
Marking Menu.
18. Select the origin point of the sketch and the
center point of the ellipse.
19. Right click and select OK; a construction line is
created between the sketch origin and the
ellipse. Also, the sketch is fully-constrained.
20. Click Finish Sketch.
21. Click 3D Model > Create > Emboss on the
ribbon; the Emboss dialog appears.
22. Select the sketch, if not already selected.
23. Click the Engrave from Face button on
the dialog.
24. Set the Depth to 0.125.
25. Click OK to create the embossed feature.
Mirroring the Emboss feature
1. Click 3D Model > Pattern > Mirror on the
ribbon.
2. Select the emboss feature from the model
geometry.
3. On the Mirror dialog, click the Mirror Plane
button, and then select the YZ Plane from the
Browser window.
4. Click OK to mirror the emboss feature.
400