AutoCAD 2018 and Inventor 2018 Tutorial By Tutorial Books (www.engbookspdf.com)

Part 2: Autodesk Inventor Basics
6. Click OK to create the chamfer.
7. Save the model and close it.
5. Click the Offset button on the Modify panel.
TUTORIAL 2
In this tutorial, you will create the model shown in
figure.
6. Select the sketch and specify the offset position.
Creating the first feature
1. Open a new Inventor part file using the
Standard.ipt template (See Chapter 2, Tutorial 3,
Starting a New Part File section).
2. On the ribbon, click 3D Model > Sketch > Start
7. Click the Line button and draw lines closing
the offset sketch.
2D Sketch .
3. Select the YZ plane.
4. Draw an L-shaped sketch using the Line tool
and dimension it.
386