AutoCAD 2018 and Inventor 2018 Tutorial By Tutorial Books (www.engbookspdf.com)

Part 2: Autodesk Inventor Basics
Length, Width, and Height boxes, respectively.
10. Click OK, and then click Finish Freeform.
11. Save and close the file.
4. Start a sketch on the new plane.
5. Place a point and add dimensions to it.
TUTORIAL 6
In this tutorial, you create a bolt.
Start a new part file
1. Start a new part file using the Standard.ipt
template (See Chapter 2, Tutorial 3, Starting a
New Part File section).
2. On the ribbon, click 3D Model > Primitives >
6. Click Finish Sketch.
7. Activate the Freeform Box tool.
8. Select the new plane and click on the sketch
point.
9. On the Box dialog, type-in 27, 16, and 3 in the
Primitive drop-down > Cylinder .
3. Click on the YZ Plane.
4. Click the origin point of the sketch to define the
center point of the circle.
5. Move the pointer and type-in 0.75 in the box,
and then press Enter.
416