AutoCAD 2018 and Inventor 2018 Tutorial By Tutorial Books (www.engbookspdf.com)

Part 1: AutoCAD Basics
base point. Move the pointer upward and
type-in 1 in the command line, and then
press Enter.
Create an opening on the rear side of the
plan, as shown below.
On the ribbon, click Home > Modify >
Explode, and select the rectangle. Press
Enter to explode the rectangle.
Activate the Offset command and specify 2
as the offset distance.
Offset the left and right vertical lines of the
rectangle.
Now, you will create sliding door in the
opening.
Activate the Rectangle command and select
the corner point of the opening, as shown
below.
Click the down arrow next to the Object
Snap icon on the status bar, and then select
Midpoint from the flyout.
Activate the Line command and select the
midpoints of the offset lines. This creates a
line connecting the offset lines. This creates
one part of the sliding door.
Select the Dimensions option from the
command line.
Specify 37 and 2 as length and width of the
rectangle, respectively.
Move the pointer upward and click to create
Press Esc to deactivate the line command.
the rectangle.
Type-in CO in the command line and press
Enter.
Drag a selection window covering all the
elements of the sliding door. Press Enter.
Type M in the command line and press
Enter. Select the rectangle, and then press
Enter.
Select its lower left corner point to define the
294