AutoCAD 2018 and Inventor 2018 Tutorial By Tutorial Books (www.engbookspdf.com)

Part 2: Autodesk Inventor Basics
values (5, 0.75, and 3) in the Height, Headwidth,
and Threadlength boxes. This creates the second
version of the bolt.
This opens the iPart Author dialog. In this dialog,
you will define the parameters to create other
versions of the model geometry.
11. In the third row of the table, type-in new values
in (2, 0.75, and 3) the Headsize, Headwidth, and
Threadlength boxes. This creates the third
version of the bolt.
Now, you have to set the default version of the bolt.
The table at the bottom of this dialog shows the
parameters for the iPart factory. You will notice that
the renamed parameters are automatically added to
the table. If you want to add more parameters to the
table, then select them from the section located at the
left side. Click the arrow button pointing towards
right. Likewise, if you want to remove a parameter
from the table, then select it from the right side
section and click the arrow pointing toward left.
8. Now, click the right mouse button on the table
and select Insert Row. Notice that a new row is
added to the table.
12. Click the right mouse button on the third row of
the table and select Set As Default Row.
13. Click OK to close the dialog. Notice that the
default version of the bolt changes.
9. Likewise, insert another row.
In the Bowser Bar, you will notice that the Table
item is added.
10. In the second row of the table, type-in new
14. Expand the Table item in the Browser Window
420