eWON Family - eWON Support
eWON Family - eWON Support
eWON Family - eWON Support
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
6.7.4.2 Activate Energy debug mode<br />
General Reference Guide Monitoring Web Interface<br />
Figure 136: Activate Energy debug<br />
6.7.4.3 Activate Serial debug mode<br />
You can activate the debug mode on every serial port of the <strong>eWON</strong> (COM port(s) and Modem).<br />
Syntax is SerDebX:Y X is the Serial port number and Y is the debug mode.<br />
To enable the Serial debug mode on Serial port 1, you need to send by FTP a “config.txt” file containing only:<br />
Or you can use a little Script Basic:<br />
<strong>eWON</strong> type Serial port number ( X )<br />
<strong>eWON</strong>4002<br />
1 : Serial port 1<br />
2 : Modem<br />
3 : Serial port 2<br />
4 : Serial port 3<br />
<strong>eWON</strong> MPI 1 : Modem<br />
Other <strong>eWON</strong>s<br />
1 : Serial port 1<br />
2 : Modem<br />
Table 134: Serial Debug : Serial port available<br />
Debug mode value (Y) Description<br />
:<br />
:System<br />
SerDeb1:1<br />
0 No debug<br />
1 Hex values Tx & Rx<br />
2 Hex and Ascii values Tx & Rx<br />
3<br />
Hex and Ascii values Tx & Rx<br />
but Rx timeouts are not logged (clearer in log)<br />
(usefull for Modem debugging)<br />
Table 135: Serial Debug : mode values<br />
Setsys SYS,”load”<br />
Setsys SYS,”SerDeb1”,1<br />
Setsys SYS,”save”<br />
cfgsave : REM to debug also after reboot<br />
RG-001-0-EN ver 1.6 <strong>eWON</strong>® - 22/06/2009 - ©ACT'L sa Page 162