eWON Family - eWON Support

When using modem port for VCOM, the following must be considered:
General Reference Guide eWON Configuration
• Modem serial port is normally owned by PPP:
• If an SMS transfer is in progress and a VCOM client tries to connect, the VCOM connection will fail.
• If a VCOM client is connected, and an SMS must be sent, the SMS sending will fail.
• When an SMS transfer or a VCOM connection ends, the PPP is again the owner of the modem serial port.
3.3.2.4 SMTP (mails) setup
Figure 16: eWON setup SMTP page
Control Description
SMTP server address
Table 8: eWON SMTP controls
After having encoded your parameters, go to the bottom of the page to .
3.3.2.5 NTP (time) setup
The IP address of the SMTP server which the Email notification will be sent to. Put SMTP server IP address. If
you only know the name of the SMTP server (like smtp.domain.com) see the chapter “Finding the IP address of
a given host” on page 200. Note that it is possible to send mails towards an Exchange server when eWON is
located inside an Intranet, providing the IMC (Internet Mail Connector) ad-in is installed on the Exchange Server,
and this service is configured to accept incoming mails sent by the eWON.
SMTP Server port Usually the value is 25. In case of doubt, contact your Internet provider or your Network Administrator to check it.
Email "From" User name
The name of the eWON Email account. For instance: ewon@compuserve.com. Will appear in the FROM field of
the message sent.
User name SMTP AUTHENTICATION: insert here the user name. (leave empty if no authentication is required)
Password SMTP AUTHENTICATION: enter here the password. (leave empty if no authentication is required)
Figure 17: eWON NTP setup page
RG-001-0-EN ver 1.6 eWON® - 22/06/2009 - ©ACT'L sa Page 19