eWON Family - eWON Support

3.3.4.2.4 VPN
General Reference Guide eWON Configuration
Figure 34: VPN Global setup page
Control Description
Diagnosis level
Port In
Choose the level of diagnosis reported in the “Real Time Log” on page 161.
Level could: None, Low, Medium or High
The TCP Port number where eWON will listen all incoming VPN traffic.
port 0 Only this port could be use for incoming VPN traffic.
0 = default behavior
• If VPN is initiated by the eWON (contacting eSync), the incoming port will be set dynamically
• If VPN is initiated by an external source (eCatcher), the eWON listens on the port 1194
(hardcoded)
Port Out The TCP Port number where eWON will send all outgoing VPN traffic (default 1194)
‘Keep alive’ interval
VPN Driver Mode
VPN Protocol
Set at which interval (in second) the eWON send a short packet to maintain the connection
opened.
Select the VPN driver mode you need. Available mode are:
• TAP
• TUN
Select the VPN protocol you need. Available protocol are:
• UDP
• TCP
Talk2M PRO Account name Holds the Talk2M-Pro Account name used by eWON.
Talk2M Access Server
Address
Holds the name or IP address of the Talk2M Access Server you want to use.
Some place holders names are defined:
• talk2m_free_eu This is the European Talk2M Free Server, used by all account created
before June 2009 and this is the default Talk2M Free Server.
• talk2m_free_us Used by people who created there account on the Talk2M Free server
located in the USA (server launched in June 2009).
• talk2m_pro This is the Talk2M PRO master access server.
Table 33: VPN Global parameters
RG-001-0-EN ver 1.6 eWON® - 22/06/2009 - ©ACT'L sa Page 42