05.01.2013 Views

eWON Family - eWON Support

eWON Family - eWON Support

eWON Family - eWON Support

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Ethernet WAN Connection - Disconnection sequence (since firmware 5.4)<br />

Connection:<br />

- Ethernet WAN interface is pulled up (the Link Led will lighten if a cable is connected)<br />

- Apply DNS server change if valid<br />

- Configure the Default gateway for the interface if valid<br />

Disconnection:<br />

- Remove the default gateway if it was configured during connection<br />

- Pull down the Ethernet WAN interface (the Link Led will go off)<br />

- Remove the DNS configuration if it has changed<br />

Since firmware 5.4, the WAN Link Led behavior depends on your configuration.<br />

It is not only hardware related.<br />

By default, the WAN Link Led is off even if a cable is plugged.<br />

General Reference Guide <strong>eWON</strong> Configuration<br />

Ethernet WAN permanently activated (before firmware 5.4)<br />

Before revision 5.4, the WAN Ethernet interface was configured during <strong>eWON</strong> boot time. When the Internet connection was “activated” by the<br />

WAN management, the Interface configuration was not affected, only the gateway configuration was modified.<br />

Since version 5.4, the WAN Ethernet interface is managed like the PPP interface i.e. it is pulled up when activated and pulled down when<br />

deactivated.<br />

Consequently, the WAN Ethernet IP configuration can be changed and the new configuration will be applied the next time the interface goes up.<br />

3.3.4.2.5.3 PPP (Point-to-Point Protocol)<br />

In the <strong>eWON</strong>, the PPP is the Modem connection<br />

This PPP connection could<br />

- be an Incoming or Outgoing modem connection<br />

- update the default Gateway of the <strong>eWON</strong><br />

- be considered as a WAN<br />

Depending of the PPP connection type, the Gateway (GW) and/or the WAN are presents.<br />

(*) Only if “Use incoming for outgoing” is checked<br />

PPP connection type Gateway WAN<br />

default Outgoing connection<br />

(<strong>eWON</strong> acts as PPP client)<br />

Callback to “Primary/Secondary server”<br />

Outgoing connection<br />

(<strong>eWON</strong> acts as PPP client)<br />

Callback to “User Defined Phone Number”<br />

Outgoing connection<br />

(<strong>eWON</strong> acts as PPP client)<br />

Incoming connection<br />

(<strong>eWON</strong> acts as PPP server)<br />

Table 34: PPP: Gateway and WAN<br />

Yes Yes<br />

Yes Yes<br />

No No<br />

Yes (*) No<br />

RG-001-0-EN ver 1.6 <strong>eWON</strong>® - 22/06/2009 - ©ACT'L sa Page 48

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!