eWON Family - eWON Support
eWON Family - eWON Support
eWON Family - eWON Support
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
3.7 Script Setup<br />
General Reference Guide <strong>eWON</strong> Configuration<br />
The Script setup page that you can reach by clicking on the Script Setup link from the configuration navigation bar is used to create, modify or<br />
erase the scripts in the <strong>eWON</strong> and to test them.<br />
Basic is the language that is used to write these scripts.<br />
Further information about the structure and the syntax of this language is given in “<strong>eWON</strong> Programming Manual”.<br />
Figure 66: <strong>eWON</strong> script section page<br />
The 3 available links in the script setup page are:<br />
• The Edit Scripts link: to create, modify or delete the scripts<br />
• The Script Control link: to test the scripts and enter one-shot commands<br />
• The Run/Stop link: to run or stop the Basic scripts<br />
3.7.1 The Edit script link<br />
The 2 predefined scripts that are present in the <strong>eWON</strong> are:<br />
• The Init section, which is executed once at the startup of the <strong>eWON</strong>.<br />
• The Cyclic section, which is executed cyclically by the <strong>eWON</strong>.<br />
This page is used to create, delete or edit script sections.<br />
• The cycle time of the <strong>eWON</strong> BASIC is not pre-determined!<br />
• This cycle depends on script itself.<br />
• If well programmed, you can achieve the cycle time within one second.<br />
RG-001-0-EN ver 1.6 <strong>eWON</strong>® - 22/06/2009 - ©ACT'L sa Page 80