Passport® - Mindray

SpO2 Monitoring SpO 2 Pulse Oximetry
6.4.3 DPM SpO 2
The digital SpO2 value displays on the SpO2 LED (7), and the SpO2 Pulse Rate displays on
the Pulse Rate LED (6).
CAUTION: When equipped with DPM SpO2, use only DPM oxygen
sensors and cables. Use of other oxygen sensors may cause
improper oximeter performance.
NOTE: Refer to instructions included with each SpO 2 sensor and
cable for proper placement and use.
NOTE: Consideration should be given to the disposal of packaging
waste.
1. Select an SpO 2 sensor that is appropriate for the patient size.
2. Attach the connector of the SpO 2 sensor to the SpO 2 extension cable.
3. Attach the SpO 2 sensor to the patient’s finger (or other appropriate site).
4. Align the key slot on the connector on the end of the SpO 2 extension cable with the
SpO 2 receptacle on the right side panel of the Passport V. Push the connector into the
SpO 2 receptacle until a “click” is heard. The SpO 2 measurement displays when the
Passport V detects that the sensor is connected to the patient. A plethysmogram
displays to the left of the SpO 2 numeric tile (if SpO 2 is selected in the TRACE SETUP
menu).
NOTE: To disconnect the cable from the Passport V, pull straight out
on the collar of the connector marked with two arrows.
Monitoring with a Reusable Y Sensor (Adult and Pediatric)
The reusable Y SpO2 sensor consists of the sensor and its sheath. One side of the sensor has
an LED with an infrared detector and the other side has a pulse detector.
1. Insert the LED and pulse detector ends of the Y SpO 2 sensor into the respective grooves
of the sheath (see FIGURE 6-4 and FIGURE 6-5).
FIGURE 6-4 Inserting the Y SpO 2 sensor into the sheath
Passport V Operating Instructions 0070-10-0704-02 6 - 9