Passport® - Mindray

More documents

Recommendations

Info

SpO2 Monitoring SpO 2 Troubleshooting and SpO 2 Menu Performance Considerations 6.5 SpO 2 Troubleshooting and SpO 2 Menu Performance Considerations To ensure optimal performance, use an appropriate sensor, apply it as directed and observe all warnings and cautions. If excessive ambient light is present, cover the sensor site with opaque material. Failure to do so may result in inaccurate measurements. Light sources that can affect performance include surgical lights, especially those with a xenon light source, bilirubin lamps, fluorescent lights, infrared heating lamps, and direct sunlight. In the event that you are unable to get a reading, or the reading you get is inaccurate, consider the following: If your patient is poorly perfused, try applying the sensor to another site - such as a different finger or toe. Check that the sensor is properly aligned. In electrosurgery, make sure sensor is not too close to ESU devices or cables. Check to make sure the site area is clean/non-greasy. Clean site and sensor if needed. CAUTION: A functional tester cannot be used to assess the accuracy of the pulse oximeter probe or a pulse oximeter monitor. NOTE: If the supply mains has been interrupted during SpO 2 monitoring, the Passport V will switch power to battery backup if at least one battery has been installed and charged. If power has been completely interrupted, SpO 2 monitoring will continue when the supply mains is restored or a fully charged battery is installed, and power has been recycled to the monitor. PROBLEM REASON SOLUTION Unable to obtain SpO2 Patient has poor perfusion. Switch limbs / Notify reading physician. Sensor not on Patient. Reapply sensor. Cables loose / not Check connections, switch connected. cable. Ambient light. Switch limbs and cover sensor with opaque material. No SpO2 waveform Waveform not selected to Go to the Display Setup Display. Menu, choose to display Pleth in the waveform area. Cable or sensor not plugged in. Check cable and sensor. Passport V Operating Instructions 0070-10-0704-02 6 - 11
SpO 2 Troubleshooting and SpO 2 Menu Performance Considerations SpO2 Monitoring PROBLEM REASON SOLUTION Low amplitude SpO2 SpO2 sensor on same limb as Check sensor placement, signal cuff. move as necessary. Patient has poor perfusion. Switch limb / Notify physician. “– – –” in Digital Data Data is above maximum Check sensor placement, value. move as necessary. Switch Data is below maximum value. limb/Notify physician. Parameter is not available. Lead or sensor is off. Refer to Chapter 14.0 Messages for Physiological Alarm Messages, Technical Alarm Messages, and Prompt Messages. 6 - 12 0070-10-0704-02 Passport V Operating Instructions
Page 1 and 2:
Operating Instructions Datascope Pa
Page 3 and 4:
CapnoLine ® is a U.S. registered t
Page 5 and 6:
Table of Contents Description .....
Page 7 and 8:
Table of Contents CO 2 Monitoring (
Page 9 and 10:
Table of Contents Disposable 400 Se
Page 11 and 12:
Introduction Warnings Warnings WARN
Page 13 and 14:
Introduction Warnings WARNING: Due
Page 15 and 16:
Introduction Precautions WARNING: C
Page 17 and 18:
Introduction Precautions Placement
Page 19 and 20:
IntroductionAvoid simultaneous cont
Page 21 and 22:
Symbols and Descriptions SYMBOL DES
Page 23 and 24:
This page intentionally left blank.
Page 25 and 26:
General Product Description General
Page 27 and 28:
Keys and Front Panel General Produc
Page 29 and 30:
Keys and Front Panel General Produc
Page 31 and 32:
Display General Product Description
Page 33 and 34:
Display General Product Description
Page 35 and 36:
Physical Views General Product Desc
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Installation Menu System Configurat
Page 43 and 44:
Advanced Installation Setup Menu (N
Page 45 and 46:
Monitor Setup Menu System Configura
Page 47 and 48:
Advanced Setup System Configuration
Page 49 and 50:
Configuration Management System Con
Page 51 and 52:
Setting-up Patients Patient Managem
Page 53 and 54:
Discharging a Patient Patient Manag
Page 55 and 56:
Remote View Patient Management 3.5
Page 57 and 58:
Remote View Patient Management 3. S
Page 59 and 60:
Remote View Patient Management Remo
Page 61 and 62:
Monitor/Display Troubleshooting Pat
Page 63 and 64: ECG Screens ECG Monitoring 4.2 ECG
Page 65 and 66: ECG Screens ECG Monitoring FIGURE 4
Page 67 and 68: Menus: ECG Main and Submenus ECG Mo
Page 77 and 78: Preparation and Lead Placement ECG
Page 85 and 86: Arrhythmia Algorithm ECG Monitoring
Page 87 and 88: Arrhythmia Alarms (optional) ECG Mo
Page 89 and 90: Arrhythmia Analysis (Optional) ECG
Page 91 and 92: ST Analysis (Optional) ECG Monitori
Page 93 and 94: ST Analysis (Optional) ECG Monitori
Page 95 and 96: ECG Troubleshooting ECG Monitoring
Page 97 and 98: ECG Troubleshooting ECG Monitoring
Page 99 and 100: Resp Screens Respiration Monitoring
Page 101 and 102: Resp Menu Respiration Monitoring Re
Page 103 and 104: Respiration and CO 2 Troubleshootin
Page 105 and 106: SpO2 Screens SpO2 Monitoring 6.2 Sp
Page 107 and 108: SpO2 Menu SpO2 Monitoring SpO 2 Men
Page 109 and 110: SpO 2 Pulse Oximetry SpO2 Monitorin
Page 111 and 112: SpO 2 Pulse Oximetry SpO2 Monitorin
Page 113: SpO 2 Pulse Oximetry SpO2 Monitorin
Page 117 and 118: NIBP Description NIBP Monitoring 7.
Page 119 and 120: NIBP Screens NIBP Monitoring 7.2.2
Page 121 and 122: NIBP Menu NIBP Monitoring NIBP Menu
Page 123 and 124: NIBP Measurements NIBP Monitoring 5
Page 129 and 130: NIBP Troubleshooting NIBP Monitorin
Page 131 and 132: Temperature Screens Temperature Mon
Page 133 and 134: Temperature Probes Temperature Moni
Page 135 and 136: Temperature Probes Temperature Moni
Page 137 and 138: Temperature Troubleshooting Tempera
Page 139 and 140: IBP Description IBP Monitoring (opt
Page 141 and 142: IBP Screens IBP Monitoring (optiona
Page 143 and 144: IBP Menu IBP Monitoring (optional)
Page 145 and 146: IBP Troubleshooting IBP Monitoring
Page 147 and 148: CO 2 Screens CO 2 Monitoring (optio
Page 149 and 150: CO 2 Menu CO 2 Monitoring (optional
Page 151 and 152: CO 2 Menu CO 2 Monitoring (optional
Page 153 and 154: CO 2 Troubleshooting CO 2 Monitorin
Page 155 and 156: Description Gas Monitoring (optiona
Page 157 and 158: Gas Screens Gas Monitoring (optiona
Page 159 and 160: Gas Menu Gas Monitoring (optional)
Page 161 and 162: Gas Module Troubleshooting Gas Moni
Page 163 and 164: Description Drug Calculations Drug
Page 165 and 166:
Description Drug Calculations Drug
Page 167 and 168:
Description Drug Calculations This
Page 169 and 170:
Alarms Alarms Setting Parameter Ala
Page 171 and 172:
Alarms Alarms HIGH LOW PARAMETERS A
Page 173 and 174:
Alarms Alarms 13.1.4 Alarm Violatio
Page 175 and 176:
Alarms Alarms “Non-Lethal” Arrh
Page 177 and 178:
Alarms Alarms This page intentional
Page 179 and 180:
Physiological Alarm Messages Messag
Page 181 and 182:
Technical Alarm Messages Messages 1
Page 183 and 184:
Technical Alarm Messages Messages 1
Page 185 and 186:
Prompt Messages Messages 14.3 Promp
Page 187 and 188:
Prompt Messages Messages SpO 2 : In
Page 189 and 190:
Prompt Messages Messages NIBP: STAT
Page 191 and 192:
Prompt Messages Messages CO 2 : Low
Page 193 and 194:
Prompt Messages Messages Caused by
Page 195 and 196:
Prompt Messages Messages GM: Unknow
Page 197 and 198:
Prompt Messages Messages 14.3.12 Co
Page 199 and 200:
Prompt Messages Messages 14.3.15 Al
Page 201 and 202:
Quick Trends Trends 15.2 Quick Tren
Page 203 and 204:
List Trends Trends Modification of
Page 205 and 206:
Graphic Trends Trends As the cursor
Page 207 and 208:
OxyCRG Trends The x-axis is time, a
Page 209 and 210:
Trends Troubleshooting Trends 15.6
Page 211 and 212:
Print Setup Menu Printing Waveforms
Page 213 and 214:
Print Setup Menu Printing FIGURE 16
Page 215 and 216:
Care and Disinfection of the Passpo
Page 217 and 218:
Care and Cleaning of Reusable Cuffs
Page 219 and 220:
Battery Replacement and Maintenance
Page 221 and 222:
Care and Cleaning of 3- and 5-lead
Page 223 and 224:
ECG Accessories 18.1.3 ECG Leadsets
Page 225 and 226:
SpO 2 LNOP® YI Multisite Reusable
Page 227 and 228:
NIBP Accessories 18.3 NIBP DESCRIPT
Page 229 and 230:
IBP Accessories 18.5 IBP DESCRIPTIO
Page 231 and 232:
CO 2 18.6.3 Gas Module 3 Accessorie
Page 233 and 234:
Cables and Networking Accessories 1
Page 235 and 236:
Battery and Miscellaneous Accessori
Page 237 and 238:
Equipment Environment and Safety Sp
Page 239 and 240:
Clock Appendix 19.3 Clock Accuracy
Page 241 and 242:
Performance Characteristics Appendi
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Input/Output Communications Appendi
Page 265 and 266:
Printing Appendix 19.12 Printing In
Page 267 and 268:
Safety Designations Appendix Impact
Page 269 and 270:
Electromagnetic Capability Appendix
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Warranty Statements Appendix Calibr
Page 281 and 282:
Manufacturer’s Responsibility App
Page 283 and 284:
Glossary of Terms Glossary LA Left
Page 285 and 286:
0070-10-0704-02 Rev H July 1, 2011
show all

Passport® - Mindray

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?