Passport® - Mindray

Prompt Messages Messages
CO 2 : Low Airway Press. Measurement of Flux
Sensor in module is
less than 400
mmHg.
CO 2: High Barometric Atmospheric pressure
is too high(higher
than 790mmHg).
CO 2: Low Barometric Atmospheric pressure
is too low(lower than
428mmHg).
CO 2: FilterLine Error Filterline is leaked or
blocked.
CO 2: Initialization Error No response after
send order during
initialization.
CO 2: SelfTest Error Module can not work
because of software
fault,circuit error etc.
CO 2 : Communication Error The monitor receives
wrong responsion
from CO 2 module.
CO2: Communication Stop Sending out order is
failed during work.
CO2: Main Board Error Module has
problems.
CO 2: Replace Scrubber &
Pump
Module has
problems.
CO 2 : 15V Overrange Power supply to
module is out of
range.
CO 2: Hardware Error Module has
problems.
CO 2 : No Watertrap Not water trap on
CO 2 module
Check airway's output
and connection.
If problems remain
exist, return it to
factory for
maintaining.
Check the CO 2
connections,make sure
that the monitor
application site meets
the requirements, and
check for special
sources that affect the
ambient pressure.
Restart the monitor.
Check the CO 2
connections,make sure
that the monitor
application site meets
the requirements, and
check for special
sources that affect the
ambient pressure.
Restart the monitor.
Check if there is a leak
in the CO 2 sample line
or the CO 2 sample line
has been occluded.
Contact Technical
Support.
Contact Technical
Support.
Contact Technical
Support.
Contact Technical
Support.
Reset the module.
Contact Technical
Support.
Restart the monitor.
Contact Technical
Support.
Check power supply.
Restart the monitor.
Contact Technical
Support.
Restart the monitor.
Contact Technical
Support.
Make sure to plug-in
water trap, and make
sure it is firmly
connected and
fastened.
14 - 14 0070-10-0704-02 Passport V Operating Instructions
DPM
DPM
DPM
DPM
1DPM
2Oridion
1DPM
2Oridion
1DPM
2Oridion
1DPM
2Oridion
Oridion
Oridion
Oridion
DPM
DPM