Passport® - Mindray

Care and Cleaning of Reusable Cuffs User Maintenance
17.5 Care and Cleaning of Reusable Cuffs
NOTE: Accuracy of cuff-pressure transducers/indicators is to be
verified at intervals specified by the manufacturer.
17.5.1 Reusable Cuffs with Bladders
Take out the bladder before cleaning and disinfecting the cuff.
Cleaning
The cuff can be hand washed or machine washed in warm water or with mild detergent. The
bladder can be cleaned with a damp cloth. Air dry the cuff thoroughly after washing.
NOTE: Machine washing may shorten the service life of the cuff.
Disinfection
The cuff may be disinfected with a damp cloth with 70% isopropanol and water. It may also
be disinfected with ultraviolet. The bladder can only be disinfected with ultraviolet.
NOTE: Prolonged use of disinfectant may cause discoloration of the
cuff.
Replace the bladder after cleaning and disinfecting the cuff, as follows:
1. Place the bladder on the top of the cuff, as the figure shows.
2. Roll the bladder lengthwise and insert it into the large opening. See the figures below.
3. Hold the hose and the cuff and shake the complete cuff until the bladder is in position.
4. Thread the hose from inside the cuff, and out through the small hole under the internal
flap.
CAUTION: Do not dry clean the cuff.
Do not press the cuff with a hot iron.
Do not use detergent and disinfectant other than than 70%
ethanol or 70% isopropanol.
Clean and disinfect the cuff according to the instructions.
17 - 4 0070-10-0704-02 Passport V Operating Instructions