Modeling and Multivariate Methods - SAS

96 Fitting Standard Least Squares Models Chapter 3
Factor Profiling
You modify plot axes for the factors by selecting different radio buttons at the top left of the plot. The Lo
and Hi Limit columns at the upper right of the plot let you enter constraints for both the factors and the
response.
Surface Profiler
Note: For details about using the Surface Profiler, see the “Visualizing, Optimizing, and Simulating
Response Surfaces” chapter on page 553. For details about Surface Plots, see the “Plotting Surfaces” chapter
on page 535.
The Surface Profiler shows a three-dimensional surface plot of the response surface.
Example Using the Surface Profiler
1. Open the Odor.jmp sample data table.
2. From the red triangle next to Model, select Run Script.
3. Click Run.
4. From the red triangle menu next to Response odor, select Factor Profiling > Surface Profiler.
Figure 3.33 Surface Plot
Interaction Plots
The Interaction Plots option shows a matrix of interaction plots when there are interaction effects in the
model.
Example of Interaction Plots
1. Open the Reactor.jmp sample data table.
2. Select Analyze > Fit Model.