Administrator's Guide - Kerio Software Archive

20.4 Moderators and MembersAdd this prefix to each subjectPrefix that will be added to subjects of each message sent to this list. When a new list isopened, its name inserted in square brackets is entered to this item automatically. Theitem content can be edited and it can be left blank (if it is empty, there will be no prefixadded to the subject).Note: Prefix is not added to the subject if it is already included there — for example, inresponses to mailing list messages, subject usually follows this pattern:Re:[name of the mailing list] the original subject— if this option is disabled, the [name of the mailing list] prefix would be doubled.Hide sender’s address and...If this function is enabled, the sender’s address (the From item ) will be substituted forthe list address in each email sent to the list. If the sender does not enter his/her name,the messages will be anonymous.Note: If this option is enabled, the This list or Other address must be set in the Reply-Toitem.Permit messages with an empty subjectIf this option is disabled, only messages with a non-blank Subject are accepted. Thedecision whether to allow messages with blank subjects depends on the administrator.20.4 Moderators and MembersIn these two sections, moderators and mailing list members can be defined. The same methodis used to add moderators and members.Any user can be either a moderator or a mailing list member — the specified email addressdoes not have to belong to any of the domains defined in Kerio MailServer. In this dialog box,only the administrator is allowed to appoint moderators. Mailing list members may be addedeither by the administrator or they can subscribe via email (if the list policy allows this option— see above).New moderators/members can be added manually or by selection from the list (see figure20.5):227