Administrator's Guide - Kerio Software Archive

Chapter 32 Kerio Outlook ConnectorNameThe name that appears in sent email messages.Email AddressThe email address from which the messages are sent.Address for repliesAddress to which replies will be sent (the Reply-To: item).Note: If MS Outlook 2000 is used, changes performed on the Sender tab will takeeffect after a restart of the application.8. Click OK to confirm and save the settings and to close the wizard. The profile created canbe found in the list provided on the Mail page. Now, two options of profile modes areavailable (see figure 32.6):• Always use this profile — this option sets the new profile as default. Then, the profileincluding the new account is opened automatically upon each startup of MS Outlook.• Prompt for a profile to be used — if this option is used, a menu is opened providinga list of all profiles (see figure 32.14). Upon each startup of MS Outlook, one of theseprofiles can be selected.Figure 32.14 Choose ProfileWarning: Each MS Outlook profile may be used only by one account connected viaKerio Outlook Connector. Functionality of POP3 and IMAP accounts located in the sameprofile is not affected by Kerio Outlook Connector Store.Note: If you use MS Outlook 2000, make sure that you add Kerio MailServer and OutlookAddress Book items during configuration. In higher versions of MS Outlook, OutlookAddress Book is added automatically.Data file settingsIn order for Kerio Outlook Connector to work properly, it is necessary to set the [Kerio OutlookConnector Store] as the default data file. If the file has not been selected automatically before,it can be specified in theTools → Email Accounts→ View or Change Existing Email Accountsmenu. The Email Accounts window contains the Deliver new email to the following locationoption, where Kerio Outlook Connector Store can be selected.350