12.07.2015 Views

GP-B Post-Flight Analysis—Final Report - Gravity Probe B - Stanford ...

GP-B Post-Flight Analysis—Final Report - Gravity Probe B - Stanford ...

GP-B Post-Flight Analysis—Final Report - Gravity Probe B - Stanford ...

SHOW MORE
SHOW LESS
  • No tags were found...

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

13.1.3.7 Payload MagnetometersThe ECU houses control circuitry for four external 3-axis magnetometers, and it provides three channels ofanalog telemetry.13.1.3.8 Dewar Passive Orbital Disconnect StrutsThe ECU senses the status of the dewar Passive Orbital Disconnect Struts (PODS), which are used to thermallyisolate the dewar from the spacecraft structure surrounding it.13.1.3.9 PID Temperature ControlThe spacecraft’s main computers (CCCA and backup CCCB) use a closed loop temperature control (PID)algorithm to control all of the following ECU heaters:1. Gas Inlet (Final Filter) 1&22. Gas Inlet (Final Filter) 3&43. Quartz Block Structure (QBS)4. Cryopump5. Vacuum Shell6. Heaters for each of the four windows in the <strong>Probe</strong>A set of parameters, including the activity duration and a temperature profile is uploaded to the CCCA/CCCBcomputer, and the PID algorithm then maintains the PID heaters at their specified temperature until theparameters are changed. The PID algorithm runs autonomously and is designed for controlling complex heateroperations in orbit. Performance of the ECU during two of these complex operations, flux flushing and lowtemperature bakeout of the <strong>Probe</strong>, is summarized in the next section.13.1.4 ECU Performance During Flux Reduction & Low TemperatureBakeoutThis section describes the flux reduction and low temperature bakeout procedures that were executed duringthe Initialization and Orbit Checkout (IOC) phase of the mission. For each of these procedures, theaccompanying chart shows how well the ECU met the specified requirements and success criteria.13.1.4.1 Low Temperature BakeoutThe low temperature bakeout process involves heating the interior surfaces of the <strong>Probe</strong> while open to space inorder to desorb and remove the helium which has condensed and been adsorbed onto the <strong>Probe</strong> interiorsurfaces during spinup of the Gyroscopes. The major components used during this operation are the ECU, theECU's Thermal Control PID Algorithm, the ECU Operated, Closed and Open Loop SIA Heaters and theirassociated Temperature Monitors.Requirements: This operation will assist in reducing the measured probe pressure below X Torr. SCIT-01Para. 8.2.3Success Criteria: Heating the <strong>Probe</strong> to 6-7 K and then lowering the temperature in a ramp until the pressurewithin the <strong>Probe</strong> in within requirements.Figure 13-10 below shows the performance of the ECU during the low temperature bakeout procedure carriedout during the IOC phase of the mission.358 March 2007 Chapter 13 — Other Payload Subsystems Analyses

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!