View Document Here - Hanford Site

WHC-SD-W100-TI-003 Rev. 0
Waste Form Qualification Testing
Statement of Work W-277587
May 14, 1992
be one liter. The process shall be monitored for the parameters listed in
Table 2 during the preparation of the qualification specimens.
The specimens shall be tested to determine the final waste form properties as
listed in Table 3. Documentation supporting laboratory qualification to
perform the required testing shall be included with the work plan. The vendor
shall propose additional process parameters or waste form properties to be
monitored or tested, as may be necessary or desirable to fully define the
pr-ocessor_demonstrate_superior waste-form qualities.
5.0 ACCEPTANCE CRITERIA
Waste form testing acceptance criteria are shown in Table 3. Polymer waste
forms which do not meet all of the test acceptance criteria will not be
considered for further evaluation or for use in the WRAP 2A facility.
6.0 CONCEPTUAL DESIGN SUPPORT
The contractor shall provide support to WHC during the development of the
conceptual design report (CDR) for the WRAP 2A facility. The contractor's
technical staff shall be available for occasional telephone consultation as
required to answer questions regarding the conceptual design. Support shall
include providing process design parameters, recommendations for process
equipment selection, and review of the immobilization process conceptual
design documents. This design review will include a 2-day meeting at UE&C's
offices in Denver. The contractor shall prepare and submit a summary letter
report describing the conclusions and recommendations resulting from this
design review.
7.0 TEST PROCEDURE
The work plan shall include complete detailed descriptions of all proposed
processing equipment and laboratory apparatus to be used for preparation and
testing of the qualification specimens. Laboratory testing procedures to be
used shall conform with the methods shown in Table 3. The tests shall be
performed by laboratories which are qualified in the required test methods.
Laboratory qualification shall be demonstrated by an established QA/QC program
and- pr-ior- experi ence i-n- the- test- methods 3peci#ied. - An,- de.i ati on #rom the
test procedures listed in Table 3 must be approved in writing by WHC prior. to
performing the tests.
8.0 SAFETY
The contractor shall comply with all applicable safety regulations during the
performance of the work. Any unusual safety hazards, such as flammability,
chemical toxicity, or reactivity associated with the process technology shall
be described in the work plan, along with the procedures and equipment which
A-5