View Document Here - Hanford Site

WHC-SD-W100-TI-003 Rev. 0
Waste Form Qualification Testing
Statement of Work W-277587
May 14, 1992
will be used to mitigate safety hazards. Material safety data sheets for all
process reagents shall be submitted with the work plan.
9.0 QUALITY ASSURANCE
The contractor shall prepare a quality assurance plan describing the QA/QC
activities to be performed during the work. WHC shall review and approve the
QA plan prior to the start of testing. The plan shall include, but not be
limited to, descriptions of laboratory instrument and equipment calibration,
analysis of duplicates and blanks, and statistical validity of analytical
results. All reported results shall be fully traceable to the original data
sources. The testing laboratory shall follow QA/QC procedures that conform to
d•'-. the requirements of the testing methods in Table 3.
10.0 SCHEDULE
The schedule for performance of this work is shown in Figure 1. The
--^_--- ----iAntraCtiSi"-s-ifiail--suf"im-it the-iv0rk plan and quality assurance plan within two
weeks after award of contract. WHC review and approval of these documents
will require one week. The contractor shall submit interim progress reports
- on the work at four week intervals following approval of the work plan and
release to proceed. The second progress report should contain the results of
all laboratory testing with the exception of the long-term immersion,
biodegradation, and leachability testing. Work shall be completed by
October 16, with submittal of the final report no later than October 30, 1992.
A-6