Condair Dual 2 manual.pdf

More documents

Recommendations

Info

10 2 ... 10 bar Y8 Y7 Y6 Y5 Spray circle discharge (only with option Z409) Y11 Y10 Y9 Water jet pump On systems having a central unit with spray circle discharge (option Z409) the spray circle drain valve Y5 opens after no humidification demand has occurred for 12 hours. Then, the valves Y9, Y10 and Y11 open one after the other for approximately 60 seconds to discharge each spray circle via the water jet pump.
3.3 Scope of versions 1 Humidification unit 2 Central unit including: 2a Control unit 2b Permeate minimum pressure switch 2c Excess temperature switch of pump 2d Booster pump 2e Silver ionization unit 2f Permeate conductance sensor The Condair Dual Hybrid Humidifier is available in two versions: either as “centralized system” (type: CD ZE ...) or as “decentralized system” (type: CD DZ ...). In the centralized system the control unit, the booster pump, the silver ionization unit and the connector box are assembled and wired in the form of a so-called “central unit” on a mounting base or in a “Z409 protective cabinet”. In the decentralized system the above components can be fitted individually (decentralized). Centralized system (CD ZE ...) 4 5 6 3 1 2a 2c Z409 2g Connector box 2h Permeate maximum pressure switch 3 Electrical connectors (power supply, control or sensor signal input, connector for external safety circuit) 4 Shut-off valve (by customers) 5 Filter (by customers, max. mesh width 0.125 mm) 6 Connector (G 1/2") for fully demineralized water 2d 2b 2 Condair Dual-S 2h 2g 2f 2e 11
Page 1: 1120506 EN 0505 Hybrid Humidifier C
Page 4 and 5: 1 Introduction 1.1 To the very begi
Page 6 and 7: 2 Important notes 2.1 Correct use f
Page 8 and 9: 3 Overview of the Condair Dual Hybr
Page 12 and 13: 1 Humidification unit 2a Control un
Page 14 and 15: 4 Installation and first-time commi
Page 16 and 17: 4.2.1 Installation of the nozzle sy
Page 18 and 19: 5 8 18 Y6 (red) Y7 (blue) Y8 (yello
Page 20 and 21: 20 First attach the upper cross arm
Page 22 and 23: 22 7 7. Fix each vertical section,
Page 24 and 25: 24 Mounting and alignment of the ve
Page 26 and 27: 26 V 13 13. Mounting the brackets f
Page 28 and 29: 28 16 65 mm 16. From the back, hang
Page 30 and 31: 30 20 20. Insert in the lower flow
Page 32 and 33: 32 Install the upper flow sheets: 2
Page 34 and 35: 34 Install the tub seal: 27 27. Cut
Page 36 and 37: 4.4 Installation of the components
Page 38 and 39: 4.5 Water installation 1 Shut-off v
Page 40 and 41: 40 Notes on water installation - Th
Page 42 and 43: 4.6 Electrical installation F2 Q Ag
Page 44 and 45: 4.7 First-time commissioning 44 The
Page 46 and 47: 46 error XX XXXXXXXXXXXXXXXX Condai
Page 48 and 49: 5.4 Inquiring operating parameters
Page 50 and 51: 50 perform. [kg/h] appliance: 100 p
Page 52 and 53: 5.5 Setting up operating parameters
Page 54 and 55: 54 E Condair Dual ready and entry c
Page 56 and 57: 56 P-band 10 % integr.time 15 Min -
Page 58 and 59: Item Work to be carried out Nozzle
Page 60 and 61:
6.3 Removal and installation of com
Page 62 and 63:
6.3.2 Removal and installation of t
Page 64 and 65:
6.5 Replacement of the control unit
Page 66 and 67:
Alarm message Cause/Remedy 66 alarm
Page 68 and 69:
7.2 Failures Residual water in the
Page 70 and 71:
8 Specifications/ambient conditions
Page 72 and 73:
72 h,x diagram ∆ ∆ ∞ ∞
Page 74 and 75:
Incoming air 74 Circulating air Mix
Page 76 and 77:
Condair Dual 2 Commissioning protoc
Page 78 and 79:
9.4 Setup table silver ionization
Page 80:
Reg.No. 40002-2 Manufacturer: Axair
show all

Condair Dual 2 manual.pdf

Create successful ePaper yourself

Delete template?

Save as template?