Condair Dual 2 manual.pdf

30
20
20. Insert in the lower flow sheet between the ceramic plate and the two
vertical sections (this step must be carried out only for the lowest
ceramic element of a vertical row).
Important! Between the vertical sections with system-specific distance
the specially marked lower flow sheet must be mounted.
21
Air flow direction
Duct, top view
21. Only the rear rows of ceramic plates require the installation of
anti-drip sheets. However, the anti-drip sheets must be installed
only on the sides of the ceramic plates which overlap with the
plates of a front row (see figure above). The ceramic plates at the
very bottom require the installation of plate sealings instead of
anti-drip sheets.
Insert the anti-drip sheet on the corresponding side between the
vertical section and the overlapping ceramic plate until it comes to a
stop. Then, bend the free end of the anti-drip sheet downwards so that
it forms a curve and touches the lower ceramic plate.
anti-drip sheet