Condair Dual 2 manual.pdf

More documents

Recommendations

Info

Incoming air 74 Circulating air Mixed air Outgoing air Exhaust air Preheater Basic diagram of an enthalpy control Remark: If the temperature is changed at the preheater, the humidification of the air which can be reached by the humidifier must be adapted to the new temperature before the humidification unit. When adapting, make sure the efficiency factor of the humidifier system “η” is not exceeded according the following formula. Humidity sensor Humidity sensor Temperature sensor Temperature sensor (x2-x1) • 100 η = % xS -x1 Position encoder enthalpy control Hybrid humidifier Condair Dual Room Control signal z.B. 0...10VDC Humidity sensor as maximum limiter
9.2 Declaration of conformity We herewith declare under our sole responsibility that the “Condair Dual 2” Hybrid Humidifiers of the “CD ZE ...” and “CD DZ ...” series comply with the standards on electromagnetic compatibility according to: EN50082-2:1995 and prEN 50082-2:1996. Axair Ltd. Pfäffikon, December 22, 1997 9.3 Commissioning protocol/Maintenance record On the following two page you will find: – the “Commissioning protocol” holding the current operating parameters – the “Maintenance record” specimen (to be copied) 75
Page 1:
1120506 EN 0505 Hybrid Humidifier C
Page 4 and 5:
1 Introduction 1.1 To the very begi
Page 6 and 7:
2 Important notes 2.1 Correct use f
Page 8 and 9:
3 Overview of the Condair Dual Hybr
Page 10 and 11:
10 2 ... 10 bar Y8 Y7 Y6 Y5 Spray c
Page 12 and 13:
1 Humidification unit 2a Control un
Page 14 and 15:
4 Installation and first-time commi
Page 16 and 17:
4.2.1 Installation of the nozzle sy
Page 18 and 19:
5 8 18 Y6 (red) Y7 (blue) Y8 (yello
Page 20 and 21:
20 First attach the upper cross arm
Page 22 and 23:
22 7 7. Fix each vertical section,
Page 24 and 25: 24 Mounting and alignment of the ve
Page 26 and 27: 26 V 13 13. Mounting the brackets f
Page 28 and 29: 28 16 65 mm 16. From the back, hang
Page 30 and 31: 30 20 20. Insert in the lower flow
Page 32 and 33: 32 Install the upper flow sheets: 2
Page 34 and 35: 34 Install the tub seal: 27 27. Cut
Page 36 and 37: 4.4 Installation of the components
Page 38 and 39: 4.5 Water installation 1 Shut-off v
Page 40 and 41: 40 Notes on water installation - Th
Page 42 and 43: 4.6 Electrical installation F2 Q Ag
Page 44 and 45: 4.7 First-time commissioning 44 The
Page 46 and 47: 46 error XX XXXXXXXXXXXXXXXX Condai
Page 48 and 49: 5.4 Inquiring operating parameters
Page 50 and 51: 50 perform. [kg/h] appliance: 100 p
Page 52 and 53: 5.5 Setting up operating parameters
Page 54 and 55: 54 E Condair Dual ready and entry c
Page 56 and 57: 56 P-band 10 % integr.time 15 Min -
Page 58 and 59: Item Work to be carried out Nozzle
Page 60 and 61: 6.3 Removal and installation of com
Page 62 and 63: 6.3.2 Removal and installation of t
Page 64 and 65: 6.5 Replacement of the control unit
Page 66 and 67: Alarm message Cause/Remedy 66 alarm
Page 68 and 69: 7.2 Failures Residual water in the
Page 70 and 71: 8 Specifications/ambient conditions
Page 72 and 73: 72 h,x diagram ∆ ∆ ∞ ∞
Page 76 and 77: Condair Dual 2 Commissioning protoc
Page 78 and 79: 9.4 Setup table silver ionization
Page 80: Reg.No. 40002-2 Manufacturer: Axair
show all

Condair Dual 2 manual.pdf

Create successful ePaper yourself

Delete template?

Save as template?