Condair Dual 2 manual.pdf

28
16
65 mm
16. From the back, hang all booster elements to the upper cross arm. Use
the thread plates and the M6x12 mm hexagon socket screws to fix the
remaining brackets (2 or 4) to the booster elements (tighten the screws
by hand only to allow later adjustment of the brackets).
Couple all booster elements at the top and bottom with a connector
piece and two hexagon socket screws M6x12 mm as well as with the
short snap lashes (attach right below the long snap lashes).
Important! When mounting the lower connector piece(s) the respective
drain-off sheet(s) must be removed again.
Align the “Booster” centrally, at equal distance to the left and the right
duct walls.
Finally push the booster elements up to a distance of 65 mm below the
duct roof, then tighten the screws of the brackets.