Condair Dual 2 manual.pdf
Condair Dual 2 manual.pdf
Condair Dual 2 manual.pdf
- TAGS
- condair
- dual
- biossol.gr
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Condair</strong> <strong>Dual</strong><br />
setup level<br />
language<br />
english<br />
language<br />
english<br />
analog signal<br />
0-10 Vdc ( 81%)<br />
controller funct<br />
off<br />
language<br />
english<br />
Sprache<br />
deutsch<br />
new value<br />
deutsch<br />
old value<br />
english<br />
language<br />
english<br />
<strong>Condair</strong> <strong>Dual</strong><br />
ready<br />
Following entry of the last digit the opposite message is displayed briefly<br />
to confirm access to the setup level.<br />
Note: If you entered an erroneous code the message “incorrect code”<br />
briefly appears on the display, and subsequently you are asked to re-enter<br />
the access code.<br />
Once you have accessed the setup level, the first parameter is displayed<br />
without delay.<br />
Selection of parameters in the setup level<br />
• Use the and keys to select the desired parameter:<br />
: next parameter<br />
: previous parameter<br />
Note: The setup level is an endless loop, i.e. stepping forward from the last<br />
parameter automatically brings up the first parameter again.<br />
Changing parameters<br />
The control unit is in the setup level.<br />
• Press the key if you wish to change the current setting. The current<br />
setting starts flashing.<br />
• Press the or key to change the setting.<br />
• Confirm the new setting by pressing the key.<br />
Following confirmation of your entry, the opposite message briefly confirms<br />
the new value.<br />
Important! Wait until this message confirms the new setting before<br />
accessing the next parameter. Otherwise, the modified setting will not be<br />
stored.<br />
Note: If you press the key to confirm the current setting without modification,<br />
the opposite message is displayed briefly.<br />
Quitting the setup level<br />
Proceed as follows to escape from the setup level:<br />
• Press the key.<br />
The control unit returns to the status display.<br />
Important! All settings that have been modified and confirmed with the <br />
key before quitting the setup level are stored automatically.<br />
Note: If no key is pressed in the setup level for 10 minutes, the control unit<br />
automatically returns to the status display.<br />
53