Condair Dual 2 manual.pdf

4.7 First-time commissioning
44
The following steps are carried out upon first-time commissioning:
• Inspecting the installation
• Flushing the water circuits
• Checking the spray nozzles
• Configuring the control unit or the system, respectively
• Carrying out test runs
• Setting up the ionization current and the capacity counter of the silver
ionization according to the table in the appendix.
Since first-time commissioning is always done by a service technician of
your Condair supplier the current manual does not provide detailed information
on this procedure.
The commissioning protocol with the system configuration data can be
found in chapter 9.4.